彩票开户
行业新闻

当前位置:彩票开户 > 新闻动态 > 行业新闻

  • 射芯机出现故障怎么办?(一)
  • 本站编辑:浙江省机电设计研究院有限公司发布日期:2019-09-15 11:34 浏览次数:
射芯机如果出现了故障,厂家们心里都会很着急,想要尽快的修理解决然后使用,但是你知道射芯机出现故障的原因和解决方法吗?不要着急,浙江省机电设计研究院有限公司铸造所这就来告诉您。
 
If the core shooter fails, the manufacturers will be very anxious to repair and use it as soon as possible. But do you know the cause and solution of the core shooter failures? Don't worry, Zhejiang Institute of Mechanical and Electrical Design Co., Ltd. Foundry Institute will tell you this.
 
 
 
 
 
如果射芯机的电源指示灯和pc指示灯不亮时,可能是电源没有连接或者保险管损坏了,这时应检查电源,及时更换同规格的保险管。
 
If the power and PC indicator lights of the core shooter are not on, it may be that the power supply is not connected or the safety pipe is damaged. At this time, the power supply should be checked and the same specification of the safety pipe should be replaced in time.
 
 
 
 
 
如果射芯机的合模出现了异常,可能是射筒的进退动作和射筒压紧动作的接近开关位置不当,这时应调整两个接近开关使得射筒处于后退、松开的状态。
 
If the closing mode of the core shooter is abnormal, it may be the inappropriate position of the proximity switch of the forward and backward action of the barrel and the pressing action of the barrel. At this time, two proximity switches should be adjusted so that the barrel is in the state of retreat and loosening.
 
如果射芯机的前进射头没有反应,有可能是气压电源没有打开所以没有气压,也有可能是射筒接近位置不当,调整射筒松开接近状态就可以解决了。
 
If the forward nozzle of the core shooter does not react, it may be that the pneumatic power supply is not turned on, so there is no pneumatic pressure. It may also be that the approaching position of the barrel is inappropriate, and the adjustment of the barrel's loosening approaching state can be solved.
 
 
 
 
 
如果射芯机的射头压紧出现了异常,说明是射筒前进接近开关位置不当,这时调整射筒前进接近开关就可以了。
 
If there is abnormal pressure on the nozzle of the core shooter, it means that the position of the nozzle forward approach switch is not appropriate, then adjusting the nozzle forward approach switch can be done.